众富购彩

山东山汽工程机器(团体)无限公司
热线德律风:400-879-1999 山汽官方微信
慎重申明 购机 售后
热线德律风:400-879-1999
您此刻地点的地位: 众富购彩官网> 消息资讯 > 行业消息 >

混凝土搅拌车底盘光滑的注重事变!

所属分类:行业消息 宣布时候:2020-09-10 来历:众富购彩:http://vncarmart.net 阅读量:18

  混凝土搅拌车底盘光滑的注重事变!
  Concrete mixer chassis lubrication precautions!
  对水泥搅拌车底盘停止准确的光滑能够削减汽车整机的磨损,增添搅拌车整机的利用寿命,可是在实行光滑时应注重一下几点:
  Proper lubrication of cement mixer chassis can reduce the wear of automobile parts and increase the service life of mixer parts. However, the following points should be paid attention to when carrying out lubrication:
  1、一般利用环境下,按搅拌车厂家的颐养周期停止光滑,环境卑劣环境下要恰当延长颐养周期。
  1. Under normal use, lubrication shall be carried out according to the maintenance cycle of the mixer manufacturer, and the maintenance period shall be shortened appropriately under harsh environment.
  2、要选用划定的光滑油。代用油料须机能靠近,首要手艺目标须保障,并且用代用油合时常查抄,且延长利用周期。
  2. Select the specified lubricating oil. The performance of substitute oil must be close to each other, the main technical indexes must be guaranteed, and the substitute oil should be inspected frequently and the service life should be shortened.
  3、改换发念头机油时,要在热状况时停止,以保障油能放尽。放油时应注重查抄机油色彩是不是一般、机油有不异物,以便发明毛病隐患。待油放尽后,放油螺栓上的异物,而后拧紧。
  3. When changing the engine oil, it should be carried out in the hot state to ensure that the oil can be drained completely. Pay attention to check whether the oil color is normal and whether there are foreign matters in the oil when discharging, so as to find out the hidden trouble. After the oil is drained out, drain the foreign matters on the oil bolt, and then tighten it.
             全主动上料搅拌车
  4、停止光滑前,要洁净进口。光滑后要洁净整机外表,以避免沾上灰尘和污物。
  4. Clean the inlet before lubrication. Clean the surface of parts after lubrication to avoid dust and dirt.
  5、改换新机油滤芯,将新机油注入发念头到油尺下限。为避免在不光滑油的环境下启动发念头,应使高压油泵处于断油地位时按启动按钮,空转一下子后,再启动发念头,并低速运行。查抄机油滤清器有不渗漏,停机后,查抄并补充机油油面到油尺上。
  5. WordStr the oil filter element and fill the engine with new oil to the upper limit of the oil dipstick. In order to prevent the engine from starting without lubricating oil, press the start button when the high-pressure oil pump is at the oil cut-off position. After idling for a while, start the engine and run at low speed. Check the oil filter for leakage. After shutdown, check and replenish the oil level to the dipstick.
  6、换机油滤芯:改换机油时,机油滤清器要同时改换,在密封垫上涂上一层薄薄的油,并且紧固滤清器。
  6. Change the oil filter element: when changing the engine oil, the oil filter should be replaced at the same time. Apply a thin layer of oil on the sealing gasket and fasten the filter.

 

众富购彩官网 产物 德律风 置顶
云彩店 七星乐官网 QQ爱彩 178彩票网 十大正规平台 500vip