众富购彩

山东山汽工程机器(团体)无限公司
热线德律风:400-879-1999 山汽官方微信
慎重申明 购机 售后
热线德律风:400-879-1999
您此刻地点的地位: 众富购彩官网> 消息资讯 > 行业消息 >

全主动上料搅拌车传动油品质检测应当注重甚么?

所属分类:行业消息 宣布时候:2020-11-26 来历:众富购彩:http://vncarmart.net 阅读量:18

在装备的现实支配时代,自上料搅拌车的转移也长短常主要的构成局部。是以,咱们须要在利用进程中测试机油的品质。那末咱们若何详细运作?
During the actual operation of the equipment, the transfer from the loading mixer is also a very important part. Therefore, we need to test the quality of the oil in use. So how do we operate?
1.将自上料搅拌车停在程度外表上并拧紧手刹。
1. Park the self loading mixer on the horizontal surface and tighten the handbrake.
2.让发念头怠速运转几分钟。
2. Let the engine idle for a few minutes.
3.踩下制动踏板,将支配杆转至倒档,进步档等,并在每一个档上逗留几秒钟,以向变矩器和一切换档履行器注满液压油。后,将支配杆转到泊车地位。
3. Step on the brake pedal, turn the control lever to reverse gear, forward gear, etc., and stay at each gear for several seconds to fill the torque converter and all shift actuators with hydraulic oil. After that, turn the lever to the park position.
4.从加油管上取下主动变速箱油尺,将洁净过的油尺拔出加油管,而后将其拉出以查抄油尺上的油位。
4. Remove the automatic transmission dipstick from the oil filler tube, insert the cleaned dipstick into the filler tube, and then pull it out to check the oil level on the dipstick.
在查抄自上料搅拌车或对其遏制毛病解除之前,请先查抄变速箱油位和油质。将变速杆置于P地位,在空转时运转发念头最少几分钟,油液到达一般的任务温度,并且车辆必须停放在程度外表上,以确保差速器和油门之间的油位。传输凡是是不变的。
全主动上料搅拌车
Please check the gearbox oil level and oil quality before checking or troubleshooting the self loading mixer. With the shift lever in position P, run the engine at idle for at least a few minutes, the fluid reaches normal operating temperature, and the vehicle must be parked on a horizontal surface to ensure the oil level between the differential and the throttle. Transmission is usually stable.
卸载自上料搅拌车时的注重事变
Precautions for unloading from loading mixer
自上料搅拌车在某些修建进程中是罕见的机器车辆装备,并且在支配装备的进程中有某些防备办法。是以,让咱们看一下现今卸料进程中自上料搅拌车的注重事变。
Self loading mixer is a common mechanical vehicle equipment in some construction process, and there are some preventive measures in the process of operating the equipment. Therefore, let's take a look at the matters needing attention of the self loading mixer in the unloading process.
1.卸货前,让夹杂罐全速运转一到两分钟,使混凝土搅拌平均。若有须要,加一些水使混凝土平均夹杂并易于卸料。
1. Before unloading, let the mixing tank run at full speed for one to two minutes to make the concrete mix evenly. If necessary, add some water to make the concrete evenly mixed and easy to unload.
2.断根物料后,将汽车尽能够停放在空中上,而后弄湿料斗斜槽以便利洁净。
2. After removing materials, park the car on the ground as much as possible, and then wet the hopper chute to facilitate cleaning.
3.幸亏装置时看一下物料,以防止支配卸料杆。发展中心地位时好遏制燃油箱,以掩护加速器,支持轮等。
3. It is good to check the materials during installation to avoid operating the unloading rod. When reversing the middle position, stop the fuel tank to protect the reducer, support wheel, etc.
4.洗瓶时必须细心洗濯,并将水频频倒转两次,而后松开,后一次将水倒入水箱中放入水箱中,而后前往工位并加水完全洗濯水箱。
4. The bottle must be cleaned carefully, and the water should be turned back twice repeatedly, and then released. After that, the water will be poured into the water tank and put into the water tank. Then, return to the working position and add water to clean the water tank thoroughly.
为了确保自上料搅拌车运转时代装备的杰出运转机能,咱们但愿您必须领会这些注重事变。因为对装备的领会缺乏,是以在支配进程中防止了支配毛病,这会影响一般施工进程的进度。
In order to ensure the good operation performance of the equipment during the operation of the charging mixer, we hope you must understand these precautions. Due to the lack of understanding of the equipment, operation errors are avoided in the operation process, which will affect the progress of normal construction process.

 

众富购彩官网 产物 德律风 置顶
云彩店 七星乐官网 QQ爱彩 178彩票网 十大正规平台 500vip