众富购彩

山东山汽工程机器(团体)无限公司
热线德律风:400-879-1999 山汽官方微信
慎重申明 购机 售后
热线德律风:400-879-1999
您此刻地点的地位: 众富购彩官网> 消息资讯 > 行业消息 >

搅拌车的这些知识你都懂了吗?

所属分类:行业消息 宣布时候:2021-07-30 来历:众富购彩:http://vncarmart.net 阅读量:18

1. 普通新采办的搅拌车,在利用一两周后就须要紧固整车的螺丝,出格是毗连副梁和底盘之间的“U型”螺栓,其次是加速机与罐体之间的螺栓,紧固时,拧紧力矩应到达300-350Nm。
1. Generally, the newly purchased mixer truck needs to tighten the screws of the whole vehicle after one or two weeks of use, especially the "U-shaped" bolts connecting the auxiliary beam and the chassis, followed by the bolts between the reducer and the tank. When tightening, the tightening torque should reach 300-350nm.
2. 液压体系初度利用250小时后必然要改换高压抗磨液压油,今后每利用2500小时改换一次,但换油时候做多不得跨越一年,换油的同时更好改换散热器滤芯。
2. The high-pressure anti-wear hydraulic oil must be replaced after the hydraulic system is first used for 250 hours. In the future, it shall be replaced every 2500 hours, but the oil change time shall not exceed one year. It is best to replace the radiator filter element while changing the oil.
3. 加速机初度利用250小时要改换重负荷齿轮油,今后每2500小时改换一次,但换油时候不得跨越一年。
3. The heavy-duty gear oil shall be replaced after the reducer is first used for 250 hours, and then every 2500 hours, but the oil change time shall not exceed one year.
图片
picture
4. 一般利用进程中,当散热器真空表读数跨越0.03MPa时,应当即改换液压油和滤芯。
4. During normal use, when the reading of radiator vacuum gauge exceeds 0.03mpa, replace the hydraulic oil and filter element immediately.
全主动上料搅拌车
5. 散热器温控开关是主动节制电扇的运行和遏制,请不要随便扳动。
5. The radiator temperature control switch automatically controls the operation and stop of the fan. Please do not pull it at will.
6. 毗连底盘和液压泵间的传动轴应每周加注锂基脂光滑油。
6. The transmission shaft connecting the chassis and the hydraulic pump shall be filled with lithium grease every week.
7. 搅拌罐每次卸料终了都必须停止外部洗濯,以防罐内粘灰,最少三个月停止一次完全清算。
7. After each unloading of the mixing tank, the internal cleaning must be carried out to prevent ash sticking in the tank. It shall be thoroughly cleaned at least once every three months.
8. 罐体查抄孔,便是“人孔”用于罐体外部维修的,须要时,可翻开放出罐内的预拌混凝土。
8. The tank inspection hole is the "manhole" used for internal maintenance of the tank. If necessary, open and release the ready mixed concrete in the tank.
9. 搅拌罐导轨与托轮之直接触面每周须要加涂锂基脂光滑油。
9. The contact surface between the guide rail of the mixing tank and the supporting wheel needs to be coated with lithium grease every week.
10. 托轮每周须要加注锂基脂光滑油。
10. The supporting roller needs to be filled with lithium grease every week.
11. 卸油转轴每周加注锂基脂光滑油。
11. Fill the oil unloading shaft with lithium grease every week.
12. 支配体系每周加注锂基脂光滑油,保障支配矫捷。
12. The control system shall be filled with lithium grease every week to ensure flexible operation.

 

众富购彩官网 产物 德律风 置顶
云彩店 七星乐官网 QQ爱彩 178彩票网 十大正规平台 500vip